- #Packet tracer activity answers full
- #Packet tracer activity answers verification
- #Packet tracer activity answers mac
Note: Each seed contains variables that are independent X = indexAdds for /24 private address space
#Packet tracer activity answers full
Verify ] has received full addressing information from ]. Configure dynamic NAT with PAT using a pool name of your choice, a /30 mask, and these two public addresses:.Refer to your documentation and configure static NAT for the File Server.All IP addresses belonging to the ] address space are allowed. Configure a standard, one statement ACL number 1.Configure a default route to the Internet.Disable interfaces that should not send RIPv2 messages.Configure one network statement for the entire ] address space.Use LAN as the case-sensitive name for the pool. The port should not be disabled, but a syslog message should be captured if a violation occurs.
#Packet tracer activity answers mac
On F0/1, allow 2 MAC addresses that are automatically added to the configuration file when detected.Ports should be manually configured as access ports. Plaintext passwords should be encrypted.SSH version 2, limited to 2 authentication attempts and a 60 second timeout.Configure remote management access including IP addressing and SSH:.Implement to following requirements using your documentation: You can access all the servers and PCs for testing purposes. You do not have access to the other routers. Note: All devices in the topology except ], ], and ] are fully configured. The information is supplied when you launch the Packet Tracer activity.
#Packet tracer activity answers verification
Fill in any blanks in the Implementation and Verification steps.Complete the Addressing Table and VLANs and Port Assignments Table.Label all the device names, network addresses and other important information that Packet Tracer generated.You will need a print out of this instruction set, which will include an unlabeled topology diagram: You are required to fully document the network. Finally, you will use your documentation to verify your implementation by testing end-to-end connectivity. Then, you will implement inter-VLAN routing and NAT on a router. During implementation, you will configure VLANs, trunking, port security and SSH remote access on a switch. Make sure you have a printed version of the instructions. First, you will complete the documentation for the network. This activity includes many of the skills that you have acquired during your CCNA studies. VLANs and Port Assignments Table VLAN Number – Name 1.3.1.3 Packet Tracer – Skills Integration Challenge Addressing TableĪnswer Note: The student version has blanks in place of all variables shown in red double brackets.